Makita HW 151 Manual page 12

12
1
The appliance you have purchased is a technologically advanced
product designed by one of the leading European manufacturers
of high pressure pumps. To obtain the best performance from your
unit, read this booklet carefully and follow the instructions each
time you use it. We congratulate you on your choice and wish you
successful operation.
2
2.1.1
any products which are not compatible with the correct operation
of the appliance.
2.1.2 DO NOT direct the water jet towards people or
animals.
2.1.3 DO NOT direct the water jet towards the unit
itself, electrical parts or towards other electrical
equipment.
2.1.4 DO NOT use the appliance outdoors in case of rain.
DO NOT allow children or incompetent persons to use the
2.1.5
appliance.
2.1.6 DO NOT touch the plug and/or socket with wet
hands.
2.1.7 DO NOT use the appliance if the electrical cable is
damaged.
2.1.8 DO NOT use the appliance if the high pressure
hose is damaged.
2.1.9 DO NOT jam the trigger in the operating position.
2.1.10 Check that the data plates are affixed to the appliance, if
not, inform your dealer. Units without plates must NOT
be used as they are unidentifiable and potentially dangerous.
2.1.11 DO NOT tamper with or adjust the setting of the
safety valve or the safety devices.
2.1.12 DO NOT alter the original diameter of the spray head
nozzle.
2.1.13 DO NOT leave the appliance unattended.
2.1.14 DO NOT move the appliance by pulling on the
2.1.15 Make sure that cars do not drive over the high pressure hose.
DO NOT move the appliance by pulling on the high pressure hose.
2.1.16
2.1.17 When directed towards tyres, tyre valves or other pressurised
components, the high pressure jet is potentially dangerous. Do not
use the rotating nozzle kit, and always keep the jet at a distance of
at least 30 cm during cleaning.
2.2.1 All electrical conductors MUST BE PROTECTED against the
water jet.
2.2.2 The appliance MUST ONLY BE CONNECTED to an
adequate power supply in compliance with all
applicable regulations (IEC 60364-1).
DO NOT use the appliance with
inflammable or toxic liquids, or
.
The appliance may cause network noise DURING startup.
• Use of a safety residual current circuit-breaker (R.C.C.B.) will
provide additional protection for the operator (30 mA).
Models supplied without plug must be installed by qualified staff.
Use only authorized electrical extension leads with suitable
conductor gauge.
2.2.3
High pressure may cause parts to rebound: wear all the protective
clothing and equipment needed to ensure the operator's safety.
2.2.4 Before doing work on the appliance, REMOVE the plug.
2.2.5 Before pressing the trigger, GRIP the gun firmly to
counteract the recoil.
2.2.6 COMPLY WITH the requirements of the local water
supply company. According to EN 12729 (BA), the
appliance may only be connected to the mains drinking water
supply if a backflow preventer valve with drain facility is installed in
the supply hose.
2.2.7 Maintenance and/or repair of electrical components
MUST be carried out by qualified staff.
2.2.8 DISCHARGE residual pressure before disconnecting the
unit hose.
2.2.9 Before using the appliance, CHECK every time that the
screws are fully tightened and that there are no broken or
worn parts.
2.2.10
of the high pressure hose/electrical cable.
2.2.11 ENSURE that all people or animals keep a
minimum distance of 16 yd. (15m) away.
ONLY USE detergents which will
not corrode the coating materials