Ip Address - Supermicro Intelligent Switch User Manual

3.4

ip address

This command sets the IP address of an interface. The no form of the command resets the IP Address for
the given Interface.
ip address <ip-address> <subnet-mask> [secondary]
no ip address [<ip_addr>]
Syntax Description
ip-address - IP address
subnet-mask - Subnet mask for the associated IP subnet
secondary - Additional IP address that can be configured for the Interface
Mode
Interface Configuration Mode
•
This command is applicable in Physical Interface Mode / VLAN Interface Mode/OOB Interface
Mode
Defaults
IP Address specified in issnvram.txt is taken as default.
Example
smis(config-if)# ip address 10.0.0.3 255.255.255.0 secondary
The interface must be shutdown prior to execution of this command.
If the user deletes / modifies the IP interface that he is connected on, then the
connection to the switch is lost.
When the no ip address command is executed without the optional parameter
<ip_addr>, all the IP addresses configured over the interface are deleted.
Related Command
show ip interface - Displays the IP interface statistics and configuration
Release :
1.0
33 / 913