Set Port Gvrp - Supermicro Intelligent Switch User Manual

15.7 set port gvrp

This command enables or disables GVRP on the interface.
set port gvrp <interface-type> <interface-id> { enable | disable }
Syntax Description
interface-type - Interface type
interface-id - Interface Id
enable - Enables GVRP on the interface
disable - Disables GVRP on the interface
Mode
Global Configuration Mode
Defaults
enable
Example
smis(config)# set port gvrp gigabitethernet 0/1 disable
•
The value enable indicates that GVRP is enabled on the current port, as long as global GVRP
status is also enabled for the device.
If port GVRP state is disabled, but global GVRP status is still enabled, then GVRP is disabled on
current port. Any GVRP packet received will be discarded and no GVRP registrations will be
propagated from other ports
Related Command
show vlan port config - Displays the vlan related parameters specific for ports
Release :
1.0
313 / 913