17.6 snmp targetaddr
This command configures the SNMP target address. The no form of the command removes the
configured SNMP target address.
snmp targetaddr <TargetAddressName> param <ParamName> {<IPAddress> |
<IP6Address>} [timeout <TimeoutValue(1-1500)] [retries <RetryCount(1-3)]
[taglist <TagIdentifier | none>] [{volatile | nonvolatile}]
no snmp targetaddr <TargetAddressName>
Syntax Description
TargetAddressName - Name of the Target address (host)
Param - SNMP parameter Name
IPAddress/ IP6Address - IP/IP6 Address of the host
Timeout - The time the SNMP agent waits for a response from the SNMP Manager before
retransmitting the Inform Request Message
retries - The Maximum number of times the agent can retransmit the Inform Request Message
taglist - Tag Identifier
volatile | nonvolatile - Storage type
Mode
Global Configuration Mode
Defaults
ParamName - Internet
IPAddress - 10.0.0.10
Taglist - snmp
Storage type - volatile
Example
smis(config)# snmp targetaddr issmgr param issd 10.0.0.10 taglist
mytag nonvolatile
Target param must have been configured.
Related Commands
show snmp targetaddr - Displays the configured SNMP target Addresses
Release :
431 / 913
1.0