Grandstream Networks GXW-410x User Manual page 24

SIP Registration
Unregister on
Reboot
Register
Expiration
Local SIP port
NAT Traversal
Proxy-Require
Early Dial
Session
Expiration
Min-SE
Caller Request
Timer
Callee Request
Timer
Force Timer
UAC Specify
Refresher
UAS Specify
Refresher
Grandstream Networks, Inc.
VoIPon www.voipon.co.uk
This parameter controls whether the GXW-410x needs to send REGISTER
messages to the SIP Server. The default setting is "Yes".
Default is No. If set to yes, the SIP user's registration information will be cleared on
reboot.
This parameter allows the user to specify the time frequency (in minutes) for the
GXW-410x to refresh its registration with the specified registrar. The default interval
is 60 minutes (or 1 hour). The maximum interval is 65535 minutes (about 45 days).
This parameter defines the local SIP port the GXW-410x will listen and transmit.
The default value for Account 1 is 5060. It is 5062, 5064, 5066 for Account 2,
Account 3 and Account 4 respectively.
This parameter defines whether the GXW-410x NAT traversal mechanism will be
activated or not. If activated (by choosing "Yes") and a STUN server is also
specified, then the GXW-410x will behave according to the STUN client
specification. Under this mode, the embedded STUN client inside the GXW-410x
will attempt to detect if and what type of firewall/NAT it is sitting behind through
communication with the specified STUN server. If the detected NAT is a Full Cone,
Restricted Cone, or a Port-Restricted Cone, the GXW-410x will attempt to use its
mapped public IP address and port in all of its SIP and SDP messages. If the NAT
Traversal field is set to "Yes" with no specified STUN server, the GXW-410x will
periodically (every 20 seconds or so) send a blank UDP packet (with no payload
data) to the SIP server to keep the "hole" on the NAT open.
SIP Extension to notify SIP server that the unit is behind the NAT/Firewall.
Default is No. Use only if proxy supports 484 response.
Grandstream implemented SIP Session Timer. The session timer extension
enables SIP sessions to be periodically "refreshed" via a SIP request (UPDATE, or
re-INVITE. Once the session interval expires, if there is no refresh via a UPDATE or
re-INVITE message, the session will be terminated. Session Expiration is the time
(in seconds) at which the session is considered timed out, if no successful session
refresh transaction occurs beforehand. The default value is 180 seconds.
The minimum session expiration (in seconds). The default value is 90 seconds.
If selecting "Yes" the phone will use session timer when it makes outbound calls if
remote party supports session timer.
If selecting "Yes" the phone will use session timer when it receives inbound calls
with session timer request.
If selecting "Yes" the phone will use session timer even if the remote party does not
support this feature. Selecting "No" will allow the phone to enable session timer only
when the remote party support this feature. To turn off Session Timer, select "No"
for Caller Request Timer, Callee Request Timer, and Force Timer.
As a Caller, select UAC to use the phone as the refresher, or UAS to use the Callee
or proxy server as the refresher.
As a Callee, select UAC to use caller or proxy server as the refresher, or UAS to
use the phone as the refresher.
GXW-410x User Manual
Firmware 1.0.0.53
sales@voipon.co.uk Tel: +44 (0)1245 808195
Page 24 of 37
Updated: 04/2007
Fax: +44 (0)1245 600030