Grandstream Networks GXW-410x User Manual page 21

T 10: C
ABLE
Channels
SIP User ID
Authentication ID
Authentication Password SIP account password needs to be entered here.
Profile ID
Call Progress Tones
Channel Voice Settings
Tx to PSTN Audio Gain
(dB)
Rx from PSTN Audio
Gain (dB)
Silence Suppression
Echo Cancellation
Channel specific Setting
Grandstream Networks, Inc.
VoIPon www.voipon.co.uk
P D
HANNELS AGE EFINITIONS
Note – The channels here are basically SIP endpoints that will act as
clients registering to the SIP Server configured under the appropriate
Profile page.
It should be set same as the channel number (i.e 1, 2..4 or 8 depending on
number of FXO ports).
It is NOT the same as SIP Account ID.
This is the SIP account information. Enter the SIP User ID part of the
account.
SIP service subscriber's Authenticate ID used for authentication. It can be
identical to, or different from SIP User ID.
Note:- After entering the password, it will show up as blank but the
password still remains active.
Select the corresponding Profile ID (1/2/3). Profiles are SIP Server
configurations.
Using these settings, user can configure tone frequencies according to user
preference. By default, the tones are set to North American frequencies.
Frequencies
uncomfortable high pitch sounds. ON is the period of ringing (ON time in
ms) while OFF is the period of silence. In order to set a continuous ring,
OFF should be zero. Otherwise it will ring ON ms and a pause of OFF ms
and then repeat the pattern.
•
"Dial tone"
•
"Ringback tone"
•
"Busy/Re-order tone"
•
"Confirmation tone"
Please refer the document below to determine your local call progress
tones:-
http://www.itu.int/ITU-T/inr/forms/files/tones-0203.pdf
Channel voice settings mentioned below.
Allows user to set a value in dB for transmission to PSTN Audio Gain.
Default is 1. Range is from -12 to 12dB.
Allows user to set a value in dB for receive from PSTN Audio Gain. Default
is 0. Range is from -12 to 12dB.
This controls the silence suppression/VAD feature of G723 and G729. If set
to "Yes", when a silence is detected, small quantity of VAD packets (instead
of audio packets) will be sent during the period of no talking. If set to "No",
this feature is disabled.
When set to Y, Echo cancellation is enabled.
Channel specific settings mentioned below.
sales@voipon.co.uk
should be configured
GXW-410x User Manual
Firmware 1.0.0.53
Tel: +44 (0)1245 808195
with known values to
Page 21 of 37
Updated: 04/2007
Fax: +44 (0)1245 600030
avoid