B) Single-Head With Two Projectors - Barco MGP 15 Dicom Theater Hardware & Software Installation & User Manual

Introduction
4. Connect the I-Guard optical sensor to a free PC USB
downstream connector. If the cable is not long enough, you
have to use a USB booster/extender.
Installation of the sensor is described more in detail in the
section "MediCal and Dicom Theater software installation
and usage".

b) Single-head with two projectors

USB
RS-232
VIDEO
Proceed as follows:
1. Connect one PC video output to the first projector BNC input
by means of the DVI-to-5 BNC cable (15 m / 50 ft).
2. Connect the other video output to the second projector BNC
input by means of the DVI-to-5 BNC cable (15 m / 50 ft).
3. Connect a free PC COM port to the first projector RS-232
connector by means of a D-Sub9-to-D-Sub9 cable (15 m / 50
ft).
16
USB
RS-232
Video
USB
RS-232
Video
Figure 2
VIDEO
RS-232
VIDEO
RS-232