C) Single-Head With One Projector (Picture-In-Picture) - Barco MGP 15 Dicom Theater Hardware & Software Installation & User Manual

4. Connect a free PC COM port to the second projector RS-232
connector by means of a D-Sub9-to-D-Sub9 cable (15 m / 50
ft).
5. Connect the first I-Guard optical sensor to a free PC USB
downstream connector. If the cable is not long enough, you
have to use a USB booster/extender.
6. Connect the second I-Guard optical sensor to a free PC USB
downstream connector. If the cable is not long enough, you
have to use a USB booster/extender.
Installation of the sensor is described more in detail in the
section "MediCal and Dicom Theater software installation
and usage".

c) Single-head with one projector (picture-in-picture)

USB
RS-232
VIDEO
Proceed as follows:
1. Connect one video output to the projector BNC input by
means of the DVI-to-5 BNC cable (15 m / 50 ft).
2. Connect the other video output to the projector D-Sub15
(VGA) input by means of the DVI-to-VGA cable (15 m / 50
ft).
USB
RS-232
Video
Video
Figure 3
Introduction
VIDEO
VIDEO
RS-232
17