Controlling Multiple Projectors With Remote Control Id (Rcid); Protecting The Projector With A Pin Code - Barco F85 User Manual

6 Advanced setup

6.1 Controlling multiple projectors with remote control ID (RCID)

6.2 Protecting the projector with a pin code

33
The remote control can be operated either in 'broadcast mode', or 'individual mode'. When
several projectors are in use in an installation, individual control may be convenient. Individual
control is available either by wired remote control, using the data-jack, or by using an individ-
ual number code. For individual control, first set the individual RC ID code using the projector
menu system, see the SETTINGS sub menu. Then, to select a specific projector to control,
first press the '*' button in the lower keypad area, then the code as set in the target projector.
A code can be in the range '0'..'99'. '0' is reserved for broadcast. To select another target,
repeat the process by pressing '*' and a new code. To exit individual control, press '*''*' twice
or press '*' and '0'.
The projector may be controlled by a PIN (Personal Identification Number) code. The PIN
code is 4 digits, and if the PIN code is activated, you must enter the correct code to unlock
the projector. Factory set PIN (1234).
To activate, deactivate or change the PIN code, see the SETTINGS > PIN CODE sub menu.
If an incorrect PIN code is entered, you may try again two times.
If you fail three times in a row, a PUK (unlock) code is needed.
The PUK code is supplied with the product.
Entering the puk code correctly is the customers responsibility
If you also fail three times with the PUK code, the projector locks up permanently, and can
only be unlocked by a special service unlock code.
To access this code, you will need to contact your dealer or a service station. The service
unlock code will be generated based on a secure, encrypted number that is produced by the
projector itself. The projector will produce a new number every time.
To unlock the projector, proof of ownership must be provided by the customer
www.projectiondesign.com