Page 1
WATER PUMP WATER PUMP Model Nos. CHF2 & CHF3 • CHS3 & CHS2E • CH3D • CH2D OPERATING & MAINTENANCE INSTRUCTIONS 0104...
Page 2
Spare Parts and Service, please contact your nearest dealer, or CLARKE International, on one of the following numbers. PARTS & SERVICE TEL: 020 8988 7400 PARTS & SERVICE FAX: 020 8558 3622 e-mail as follows: PARTS: Parts@clarkeinternational.com SERVICE: Service@clarkeinternational.com...
PARTS DIAGRAM Model - CHF3 Thank you for purchasing this Clarke Water Pump, designed for pumping water, or water containing, sand, or solids in suspension, depending upon the model (please see below). Please read this leaflet thoroughly and follow the instructions carefully, in doing so...
PARTS LIST threads or the pump body. For Engine part no. - Consult your CLARKE dealer Observe all safety precautions for the handling of fuel. Never refuel the engine whilst it is running, and allow the engine to cool sufficiently before refuelling.
Page 5
Models CH2E and CH3D should be used for water only, Models CHS2E and CHS3 are semi-trash pumps, and may be used for contaminated water. Models CHF2 and CHF3, are trash pumps, for use with heavily contaminated water.
Properly fuelled and lubricated, your pump will run without attention. PARTS LIST For Engine part no. - Consult your CLARKE dealer OPERATION (Refer to the illustration on page 3) No. Description Part No.
2. PRIMING TIME. TROUBLESHOOTING With a suction lift from 5 to 10ft., the pump should discharge liquid in less than a minute. A suction lift of 25ft (at sea level) should require not more than 2 minutes NOTE: For engine problems, consult the manual supplied. for initial prime.
Need help?
Do you have a question about the CHF2 and is the answer not in the manual?
Questions and answers