NetVanta 1535P Hardware Installation Guide
Powering the NetVanta 1131 and the NetVanta Switch
Follow these instructions to power your NetVanta 1131 RPS/EPS and your NetVanta switch.
•
This unit shall be installed in accordance with Articles 300 and 400 of NEC NFPA 70.
•
Power to the AC system must be from an appropriately rated and grounded source.
•
Maximum recommended ambient operating temperature is 50
Instructions for Powering the NetVanta 1131 and the NetVanta Switch
Step
1
Plug the female end NetVanta switch's power cord (provided with the unit) into the power
receptacle on the rear panel of the unit.
2
Connect the other end (3-prong plug) of the NetVanta switch's power cord to the proper 110 to
130 VAC or 190 to 240 VAC grounded receptacle.
3
Plug the female end of the NetVanta 1131 unit's power cord (provided with the unit) into the
power receptacle labeled Power on the rear panel of the unit.
4
Connect the other end (3-prong plug) of the unit's power cord to the proper 110 to 130 VAC or
190 to 240 VAC grounded receptacle.
Your NetVanta unit is now ready to be configured and connected to the network. For information on switch
configuration for a specific application, refer to the configuration guides provided on the
Community. For details on the command line interface (CLI), refer to the
other related documents are also available online at http://supportforums.adtran.com.
61702595G10-34C
Action
Copyright © 2013 ADTRAN, Inc.
NetVanta 1131 RPS/EPS
o
C.
ADTRAN Support
AOS Command Reference
Guide. All
37