Table of Contents
Advertisement
Unit Installation
Instructions for Wall Mounting the NetVanta 1535P ActivReach Switch
Step
1
Remove the mounting brackets. Rotate them 90 degrees so that the portion of the bracket with
the mounting holes is flush with the bottom of the chassis. Reattach the mounting brackets to
the chassis (see
2
Decide on a location for the NetVanta. The NetVanta 1535P ActivReach switch is mounted with
the front panel facing down as shown in
mounted at or above eye level so that the LEDs are viewable.
3
Prepare the mounting surface by attaching a board (typically plywood, 3/4-inch to 1-inch thick)
to a wall stud using #6 to #10 (2.5-inch or greater in length) wood screws.
Important! Mounting to a stud ensures stability. Using sheetrock anchors may not provide
sufficient long-term stability.
4
Have an assistant hold the unit in position as you install two #6 to #10 (1 inch or greater in
length) wood screws through the unit's brackets and into the mounted board (see
5
Proceed to the steps given in
Figure 3. NetVanta 1535P ActivReach Switch Wallmount Installation
24
Figure
3).
Figure
Supplying Power to the Unit on page
INPUT
AC
Copyright © 2013 ADTRAN, Inc.
NetVanta 1535P Hardware Installation Guide
Action
3. Keep in mind that the unit needs to be
25.
50VDC
-
EPS
12VDC
-
RPS
Figure
3).
61702595G10-34C
Advertisement
Table of Contents
