Installing A Switch In A Rack; Figure 7. Attaching The Rack-Mount Bracket; Figure 8. Mounting The Switch On The Rack - Allied Telesis AT-9000/24 Installation Manual
Layer 2 gigabit ethernet switch
Hide thumbs
Also See for AT-9000/24:
- Installation manual (54 pages) ,
- Datasheet (2 pages) ,
- Datasheet (3 pages)
Table of Contents
Advertisement
Available languages
Available languages
Chapter 2: Installation
Installing a Switch in a Rack
36
To install the AT-9000/24 Gigabit Ethernet Switch in a rack, perform the
following procedure:
1. If attached, remove the rubber feet using a flat-head screwdriver.
2. Install a bracket on one side of the switch using a Phillips screwdriver
and four of the rack-mount screws included with the switch, as shown
in Figure 7.
804
Figure 7. Attaching the Rack-Mount Bracket
3. Repeat step 2 to attach the remaining bracket to the other side of the
switch.
4. Mount the switch on a 19-inch rack using the four large screws
included, as shown in Figure 8
Figure 8. Mounting the Switch on the Rack
805
Hide quick links:
Advertisement
Table of Contents
