Starting A Local Management Session; Figure 15. Connecting The Console Cable - Allied Telesis AT-9000/24 Installation Manual

Chapter 2: Installation

Starting a Local Management Session

Starting a Local
Management
Session
44
To start a local management session on an AT-9000/24 Gigabit Ethernet
Switch, perform the following procedure:
1. Connect one end of the management cable to the console port on the
switch, as shown in Figure 15.

Figure 15. Connecting the Console Cable

2. Connect the other end of the cable to the RS-232 port on a terminal or
PC with a terminal emulator program.
3. Configure the terminal or terminal emulator program as follows:
Baud per second: 9600
Data bits: 8
Stop bits: 1
Flow control: None
Note
These default settings are for a DEC VT100 or ANSI terminal, or an
equivalent terminal emulation program.
801