Figure 70 Remote Management: SNMP
The following table describes the labels in this screen.
Table 54 Remote Management: SNMP
LABEL
SNMP Configuration
Get Community
Set Community
Trusted Host
Trap
Community
Destination
SNMP
Service Port
Chapter 12 Remote Management Screens
DESCRIPTION
Enter the Get Community, which is the password for the incoming Get and
GetNext requests from the management station. The default is public and allows
all requests.
Enter the Set community, which is the password for incoming Set requests from
the management station. The default is public and allows all requests.
If you enter a trusted host, your ZyAIR will only respond to SNMP messages
from this address. A blank (default) field means your ZyAIR will respond to all
SNMP messages it receives, regardless of source.
Type the trap community, which is the password sent with each trap to the
SNMP manager. The default is public and allows all requests.
Type the IP address of the station to send your SNMP traps to.
You may change the server port number for a service if needed, however you
must use the same port number in order to use that service for remote
management.
ZyAIR G-2000 Plus User's Guide
164