ZyAIR G-2000 Plus User's Guide
23.2 Protocol Dependent Ethernet Setup
Depending on the protocols for your applications, you need to configure the respective
Ethernet Setup, as outlined below.
• For TCP/IP Ethernet setup refer to the Internet Access Application chapter.
• For bridging Ethernet setup refer to the Bridging Setup chapter.
23.3 TCP/IP Ethernet Setup and DHCP
Use menu 3.2 to configure your ZyAIR for TCP/IP.
To edit menu 3.2, enter 3 from the main menu to display Menu 3 — LAN Setup. When menu
3 appears, press 2 and press [ENTER] to display Menu 3.2 — TCP/IP and DHCP Ethernet
Setup, as shown next
Figure 127 Menu 3.2 TCP/IP Setup
DHCP= Server
Client IP Pool:
Starting Address= 192.168.1.33
Size of Client IP Pool= 32
First DNS Server= From ISP
IP Address= N/A
Second DNS Server= From ISP
IP Address= N/A
Third DNS Server= From ISP
IP Address= N/A
DHCP Server Address= N/A
Press Space Bar to Toggle.
Follow the instructions in the next table on how to configure the DHCP fields.
Table 87 DHCP Ethernet Setup Fields
FIELD
DHCP
Client IP Pools
Starting Address
265
:
Menu 3.2 - TCP/IP and DHCP Ethernet Setup
Press ENTER to Confirm or ESC to Cancel:
DESCRIPTION
This field enables/disables the DHCP server.
If set to Server, your ZyAIR will act as a DHCP server.
If set to None, the DHCP server will be disabled.
If set to Relay the ZyAIR acts as a surrogate DHCP server and relays requests and
responses between the remote server and the clients.
When set to Server, the following items need to be set:
This field specifies the first of the contiguous addresses in the IP address pool.
TCP/IP Setup:
IP Address= 192.168.1.1
IP Subnet Mask= 255.255.255.0
RIP Direction= Both
Version= RIP-1
Multicast= None
Edit IP Alias= No
Chapter 23 LAN Setup