Table of Contents
Advertisement
ZyAIR G-2000 Plus User's Guide
Figure 130 Menu 3.5 Wireless LAN Setup
Enable Wireless LAN= Yes
ESSID= Wireless
Hide ESSID= No
Channel ID= CH06 2437MHz
RTS Threshold= 2432
Frag. Threshold= 2432
WEP Encryption= 128-bit WEP
Default Key= 1
Key1= ********
Key2= ********
Key3= ********
Key4= ********
Authen. Method= Auto
Press Space Bar to Toggle.
The following table describes the fields in this menu.
Table 90 Menu 3.5 Wireless LAN Setup
FIELD
ESSID
Hide ESSID
Channel ID
RTS Threshold
Fragment Threshold
WEP Encryption
Default Key
269
Menu 3.5 - Wireless LAN Setup
Press ENTER to Confirm or ESC to Cancel:
DESCRIPTION
The ESSID (Extended Service Set IDentity) identifies the AP to which the
wireless stations associate. Wireless stations associating to the AP must have
the same ESSID. Enter a descriptive name of up to 32 printable 7-bit ASCII
characters.
Press [SPACE BAR] and select Yes to hide the ESSID in the outgoing data
frame so an intruder cannot obtain the ESSID through passive scanning.
Press [SPACE BAR] to select a channel. This allows you to set the operating
frequency/channel depending on your particular region.
Setting this attribute to zero turns on the RTS/CTS handshake. Enter a value
between 0 and 2432.
This is the maximum data fragment size that can be sent. Enter a value
between 256 and 2432.
Select Disable to allow wireless stations to communicate with the access points
without any data encryption.
Select 64-bit WEP or 128-bit WEP to enable data encryption.
Enter the key number (1 to 4) in this field. Only one key can be enabled at any
one time. This key must be the same on the ZyAIR and the wireless stations to
communicate.
Edit MAC Address Filter= No
Edit Roaming Configuration= No
Breathing LED= Yes
Preamble= Long
802.11 Mode= Mixed
Chapter 23 LAN Setup
Advertisement
Table of Contents
Troubleshooting
