Table of Contents
Advertisement
Chapter 8. Programming Methods
The RDK is intended for use with HEW and includes an integrated Segger J-Link Lite debugger. Refer to RX62N Group
Hardware Manual for details of programming the microcontroller without using these tools. The on-board J-Link Lite is
pre-programmed at the factory and configured for normal operation. The debugger can be disabled by fitting a jumper to
the J-Link disable 2-pin header. This is useful if the board needs to be put into either USB or UART boot mode. The
J-Link Lite is located in the upper left section of the RX62N RDK. Should the Segger Micro become inoperable – it will
need to be returned to Renesas for repair.
19
Advertisement
Table of Contents
