2
Click
next to "Backup".
3
Click List of LinkStations and TeraStations.
Check the IP address of the LinkStation or TeraStation that you want to set as the backup location. Click Add, enter the IP
address of the target LinkStation or TeraStation, and click Close.
If your setup meets these requirements, you don't have to configure these settings:
•
The source and target TeraStations are on the same network.
•
No backup password is set for the target TeraStation.
•
No TeraStation from outside the subnet, or connected by a VPN, is used.
Note:
To back up data between LinkStations or TeraStations on a network using jumbo frames, make sure that both
devices are configured to use identical (or similar) Ethernet frame sizes. If Ethernet frame sizes are significantly
different, the backup job may not be properly performed. In such a case, select the default frame size (1518 bytes).
70