Buffalo TeraStation 7000 User Manual page 56

iSCSI Setup
To use the TeraStation as an iSCSI hard drive, configure it as described below.
1
If you are using Windows XP, Windows 2000, Windows Server 2003, or Windows 2000 Server, download and install
the "Microsoft iSCSI Software Initiator" first.
2
Connect the TeraStation's Ethernet and power cables and configure the TeraStation's IP address and its clock.
3
In Settings, click Drives.
Note:
Steps 4 to 8 specify and change the size of the iSCSI-connected area. Skip to step 9 if you are using an iSCSI
connection that is based on drive or array units.
4
Choose LVM.
5
Select the drive where the volume will be created and click Enable LVM on Volume.
Notes:
• Enable LVM before using the TeraStation as an iSCSI drive.
• If the LVM settings are changed, all data on the volume will be erased. Before changing the settings, back up any
important data.
6
The "Confirm Operation" screen will open. Enter the displayed number, then click OK.
7
Click OK.
56