Cochlear CR110 User Manual page 15

To recharge your remote assistant battery using your computer and the
CR100 Series USB Cable:
1. Connect the CR100 Series
USB Cable to the USB socket
at the base of the remote
assistant.
2. Plug the other end of the
CR100 Series USB Cable
into the USB port of your
computer.
When you connect the CR100 Series USB cable to the computer, a
'New hardware found' wizard (dialog) may display on your computer.
If you have Internet access, click 'Next' on your computer to install the
software for the Cochlear CR110 device.
If you do not have Internet access, press Cancel to dismiss the wizard.
If your computer is hibernating, in standby mode, or shuts
down while charging, the remote assistant battery will stop
charging.
© Cochlear Limited 2010
Getting started
CR110 User Guide - 15