Remote Control - Sharp CD-SW250DVD Operation Manual

Remote control

CD-SW250DVD
ENGLISH
Battery installation
H
1 Open the battery cover.
2 Insert the supplied batteries according to the direction indicated in
the battery compartment.
When inserting or removing the batteries, push them towards the d battery
terminal.
3 Replace the cover.
Precautions for battery use:
I Replace all old batteries with new ones at the same time.
I Do not mix old and new batteries.
I Remove the batteries if the unit is not be used for long periods of time. This
will prevent potential damage due to battery leakage.
Caution:
I Do not use rechargeable batteries (nickel-cadmium battery, etc.).
I Installing the batteries incorrectly may cause the unit to malfunction.
Battery removal:
Open the battery cover and pull up the battery to take out.
E-17
SW250DVD_11-17_EN+ 17
Notes concerning use:
I Replace the batteries if the operating distance is reduced or if the operation
becomes erratic. Purchase 2 "AA" size batteries (UM/SUM-3, R6, HP-7 or
similar).
I Periodically clean the transmitter on the remote control and the sensor on
the unit with a soft cloth.
I Exposing the sensor on the unit to strong light may interfere with operation.
Change the lighting or the direction of the unit.
I Keep the remote control away from moisture, heat, shock and vibrations.
Test of the remote control
H
Check the remote control after checking all the connections have been made
correctly. (See pages 11 - 16).
Point the remote control directly at the remote sensor on the unit.
The remote control can be used within the range shown below:
Press the ON/STAND-BY button. Does the power turn on? Now, you can enjoy
music.
DVD MINI SYSTEM
CD-SW250DVD
0.2 m - 6 m
(8" - 20')
27/4/05, 4:30 PM
Remote sensor