Remote Control - Sharp CD-BH10 Operation Manual

Controls and indicators (continued)

■ Remote control

1
2
3
TIMER
4
5
6
7
FOLDER
8
9
TUNING
10
11
12
13
92L1R15102733A
1.
STANDBY: Press to turn on or enter standby.
2.
CLOCK: Press this to enter Clock mode.
3.
SLEEP: Press this to select a sleep time.
4.
DIMMER: Press this to adjust the display brightness.
5.
PROG/MEMORY: Press this to select a preferred
station and save.
6.
FAST REWIND/PREVIOUS: Press this to return
to the previous track and hold down for fast rewind
playback.
7.
PLAY/PAUSE: Press this to pause a playback and
press it again to resume the playback.
8.
FOLD+: Press this to skip the next folder.
9.
FOLD-: Press this to return to the previous folder.
10.
10+/TUNING : Press this to forward ten tracks or
fine tune (increase) the frequency.
11.
10-/TUNING : Press this to rewind ten tracks or fine
tune (decrease) the frequency.
12.
VOL -: Press this to decrease volume.
13.
EQ: Press this to select the sound equalizer pre-set.
14.
OPEN/CLOSE: Press this to open or close the disc
tray.
CD-BH10_EN.indd 9 CD-BH10_EN.indd 9
14
15
INPUT
16
MEMORY
17
18
19
20
21
15.
INPUT: Press this repeatedly to switch between CD,
LINE IN, BLUETOOTH, USB, and FM TUNER modes.
16.
REPEAT: Press to repeat the song in CD mode.
17.
FAST FORWARD/NEXT: Press this to skip to the next
track and hold down for fast forward playback.
18.
RANDOM: Press this to play music in random order.
19.
STOP/AUTO: Press this to stop a playback or hold
down to do auto-scanning. Press it again to stop auto-
scanning.
20.
VOL +: Press this to increase volume.
21.
MUTE: Press this to turn off the sound temporarily.
Press it again to turn it on.
Fitting or replacing the remote control battery
Use 1 "AAA" size battery (UM/SUM-4, R3, HP-16 or similar).
1. Remove the battery compartment cover on the back of
the remote control.
2. Load one AAA/1.SV
compartment making sure that the battery have
been inserted with the correct polarities matching
the symbols +, - as indicated inside the battery
compartment.
3. Replace the battery cover and clip it in place.
Caution:
●
Remove the battery if the unit will not be used for a
long period of time. This will prevent potential damage
due to battery leakage.
●
Do not use rechargeable battery (nickel-cadmium
battery, etc.).
●
Batteries (battery pack or battery installed) shall not
be exposed to excessive heat such as sunshine, fire
or the like.
●
Risk of fire explosion if the battery is replaced by an
incorrect type.
●
Installing the battery incorrectly may cause the unit to
malfuction.
Notes concerning use:
●
Exposing the sensor on the unit and remote control to
strong light may interfere with operation. Change the
lighting or the direction of the unit if this occurs.
●
Keep the remote control away from moisture, heat
shock, and vibrations.
E-9
battery into the battery
7/7/23 2:49 PM 7/7/23 2:49 PM