Dubbing From Tape To Tape - Sharp CD-SW250DVD Operation Manual

Recording to a cassette tape (continued)
CD-SW250DVD
ENGLISH

Dubbing from tape to tape

H
You can record from TAPE 1 to TAPE 2.
1
Press the ON/STAND-BY button to turn the power on.
2
Load a prerecorded cassette into the TAPE 1 cassette
compartment. Insert a blank tape into the TAPE 2 cassette
compartment.
It is recommended that the recording tape is the same length as the
master tape.
3
Press the TAPE (1 V 2) button
until "TAPE 1" appears on the
display.
The reverse mode will be set to " é".
4
Press the REC PAUSE (I6) but-
ton.
Recording will be paused.
5
Press the 0 button to start dubbing.
To stop dubbing:
Press the H (H) button.
TAPE 1 and TAPE 2 will simultaneously stop.
E-63
SW250DVD_58-63_EN+ 63
Erasing recorded tapes
H
1. Load the tape to be erased into the TAPE 2 cassette compartment with the
side to be erased facing towards you.
2. Press the TAPE (1 V 2) button until "TAPE 2" appears on the display.
3. Set the ƒ button to "é" to erase only one side and to "©" to erase both
sides.
4. Press the REC PAUSE ( I6 ) button.
5. Press the 0 button to erase side A, or the 1 button to erase side B.
To erase both sides, begin with side A. (If erasing is started from side B, the
tape will not switch over to side A.)
Note:
Make sure that the TAPE 1 is not in use.
27/4/05, 11:04 AM