Procedure 11-2 To Create A Vll Cpipe Service On A 9500 Mpr - Alcatel-Lucent 5620 User Manual

11 — 9500 MPR VLL service management
28 Perform one of the following:
a
b
29 Click on the OK button. The Apipe Service (Create) form closes.
You can use the service topology maps to view the service.

Procedure 11-2 To create a VLL Cpipe service on a 9500 MPR

1 Choose Create→Service→9500 VLL→Cpipe (CEM to CEM/Eth) from the 5620 SAM
main menu. The Cpipe Service (Create) form opens with the General tab
displayed.
2 Click on the Select button to choose a customer to associate with the Cpipe
service. The Select Customer - Cpipe Service form opens.
3 Choose the Default Customer as the customer for the Cpipe service and click on
the OK button. The Select Customer - Cpipe Service form closes and the Cpipe
Service (Create) form reappears with the customer information displayed.
4 Configure the parameters:
•
•
•
•
•
•
The Service ID parameter is configurable when the Auto-Assign ID parameter is
disabled.
The SVC Mgr Service ID parameter is configurable when the Auto-Assign ID
parameter is disabled.
The Current OLC State parameter is configurable when you click on the Apply
button.
11-6
Create another site for the VLL service, if required. Repeat steps
Complete service creation. Go to step 29.
Note — If service creation fails or generated NE inconsistencies occur,
see Procedure 4-2.
Service ID
Auto-Assign ID
SVC Mgr Service ID
Service Name
Description
Service Tier
Note — To create a 9500 MPR Cpipe service with an ERPS tail node, set
the Path Type parameter to Ring Based.
September 2013 Alcatel-Lucent 5620 Service Aware Manager, Release 11.0 R5
Service Priority
•
Specify VLAN Path
•
Path Type
•
• Current OLC State
Revert OLC State
•
3HE 08459 AAAA TQZZA Edition 01
MPR User Guide
9 to 27.