Procedure 10-2 To Create A 9500 Mpr Vlan Path - Alcatel-Lucent 5620 User Manual

9 If you need to apply a span of control to a group, other than the default, click on
the Spans tab. Otherwise, go to step 10.
i
ii
iii
iv
10 Click on the OK button. A dialog box appears.
11 Click on the Yes button. The VLAN Group (Edit) form closes.
12 A list of VLAN groups appears in the Manage VLAN Groups form.
13 Close the Manage VLAN Groups form.

Procedure 10-2 To create a 9500 MPR VLAN path

1 Choose Manage→VLAN→Paths from the 5620 SAM main menu. The Manage VLAN
Paths form opens.
2 Click on the Create button. The Create VLAN Path form opens with the Path Type
step displayed.
3 Configure the Path Type parameter.
4 Click on the Next button. The Identification step appears.
5 Configure the parameters:
•
•
•
Alcatel-Lucent 5620 Service Aware Manager, Release 11.0 R5
3HE 08459 AAAA TQZZA Edition 01
MPR User Guide
Click on the Create button. The Select Span(s) - VLAN Group form opens with
a list of available spans.
Choose one or more spans of control to apply to the VLAN group.
Click on the OK button. The Select Span(s) - VLAN Group form closes and a
dialog box appears.
Click on the OK button.
Note 1 — To create a ring-based VLAN path, you need a radio ring
element; see Procedure 9-1.
Note 2 — When you create an Auto or P2P variant of a hop-based VLAN
path, all 9500 MPR NEs that traverse the VLAN path must be part of the
same VLAN group. For manually created VLAN paths, a VLAN group is not
required. See Procedure
groups.
Note 3 — You can also use this procedure to provision a VLAN path for
a tail node.
Name
Description
Creation Type
The Creation Type parameter appears when the Path Type parameter is set to
Hop Based.
10 — 9500 MPR VLAN service management
10-1 for information about creating VLAN
September 2013 10-5