Yamaha TNR-W Manual page 35

Using the [R5] Button to Copy Layers
By holding the [R5] button and performing the operations described below you can copy
either a single layer or all layers from the current block to another block.
1. If the current block is not the block containing the layers you want to copy, hold the
[R5] button and press the LED button corresponding to the desired "source" Block (the
LEDs in that column will light dimly).
2. If you repeatedly press the lowest LED button in the lit column while holding the [R5]
button, the LED buttons in the lit column will switch between three levels of brightness
in the following sequence: dim ➝ medium ➝ bright ➝ dim. The functions
corresponding to each brightness level are: dim = block move, medium = copy 1 layer,
bright = copy all layers. The procedures to copy 1 or all layers are described below.
To Copy a Single Layer
While holding the [R5] button while the LED buttons are lit dimly, press the lowest LED
button in the lit column once so that the LED buttons shine at medium brightness, and
then press an LED button in column corresponding to the block you want to copy to.
The current layer from the source block will be copied to the same layer in the
destination block. Release the [R5] button.
To Copy All Layers
While holding the [R5] button while the LED buttons are lit dimly, press the lowest LED
button in the lit column twice so that the LED buttons shine at maximum brightness,
and then press an LED button in column corresponding to the block you want to copy
to. All layers from the source block will be copied to the destination block. Release the
[R5] button.
When the copy operation is complete the destination block will be selected and the
LED buttons will automatically return to their minimum brightness level.
Setting Parameters with the Function Buttons
Parameter Settings
[R5] Block Number
35
TENORI-ON Manual