Yamaha TNR-W Manual page 114

Symptom
SD Memory Card
Can't record or play.
Cannot perform file operations.
A loaded All Blocks, Current Block, or
Current Layer file does not play
automatically.
Others
The loop indicator doesn't move.
The loop point and/or loop speed settings
have changed.
Possible Cause & Solution
The SD Memory Card is write-protected. Set the card's write-protect
switch to the OFF position.
Too much performance data. Performances that exceed 39KB (About
1000 operations) cannot be recorded.
Not enough remaining SD Memory Card capacity. Use a different SD
Memory Card.
Save and rename operations can only be performed on up to 100 files
that have file names in which the first five characters are the same.
The SD Memory Card is write-protected. Set the card's write-protect
switch to the OFF position.
Not enough remaining SD Memory Card capacity. Use a different SD
Memory Card.
The maximum number of files has been exceeded. Up to 1,000 files
can be stored in the TENORI-ON folder, or up to 256 files of each file-
extension type.
If playback is paused when a file is loaded, the loaded file will not be
played automatically. Return to the status display and press the [OK]
button to begin playback.
The pause mode may have been engaged by pressing the [OK]
button. Press the [OK] button a second time.
These settings change when the Play menu Master Loop Point and
Master Loop Speed settings are changed.
Appendix
Troubleshooting
Page
page 63
–
–
–
page 63
–
page 62
–
–
–
114
TENORI-ON Manual