Setting Up - Connection To The Power Supply - Nilfisk-Advance WSS 100 Instructions For Use Manual

WSS100 - WST100 DV
Setting up - connection to the power
supply
WARNING!
• Make sure that the vacuum cleaner is in good
condition before starting work.
• Before plugging the vacuum cleaner into the
electrical mains, make sure that the voltage rating
indicated on the data plate corresponds to that of
the electrical mains.
• Plug the vacuum cleaner into a socket with a
properly installed ground connection. Make sure
that the vacuum cleaner is off.
• The plugs and connectors of the connection
cables must be protected against splashing water.
• Make sure that connections to the electrical mains
and plug are correct.
• Use the vacuum cleaner only when the cables
that connect to the electrical mains are in good
condition (damaged cables could lead to electric
shocks!).
• Regularly check that the electric cable does not
show signs of damage, excessive wear, cracks or
aging.
WARNING!
When the vacuum cleaner is operating:
• Do not crush, pull, damage or tread on the cable
that connects to the electrical mains.
• Only disconnect the cable from the electrical
mains by removing the plug (do not pull the cable).
• Only replace the electric power cable with one of
the same type as the original (H05 VV-F); the same
rule applies if an extension is used.
• The cable must be replaced by the manufacturer's
Service Centre staff or by equivalent qualified
personnel.
09/2009
The vacuum cleaner's power socket must be protected
by a differential circuit-breaker with surge current
limitation, that shuts off the power supply when the
current discharged to the ground exceeds 30 mA for
30 msec. or an equivalent protection circuit.
Never spray water on the vacuum cleaner: this could
be dangerous for persons and could short circuit the
power supply.
4
WARNING!
WARNING!