Emptying The Chip Basket; At The End Of A Cleaning Session; Maintenance, Cleaning And Decontamination - Nilfisk-Advance WSS 100 Instructions For Use Manual

Emptying the chip basket

1 Chip basket
2 Container closing band
3 Motorhead (WST 100 DV)
4 Motorhead (WSS 100)
WARNING!
Before proceeding with these operations, turn off the
vacuum cleaner and remove the plug from the power
socket.
Lift the container with a suitable lifting device.
• Open the container closing band (2) and lift off/tilt back
the vacuum cleaner motor head.
• Remove the chip basket.
• Empty the basket and clean it (see "Cleaning the
containers" paragraph).
• Place the chip basket back in position, making sure it is
correctly positioned.

At the end of a cleaning session

• Turn off the vacuum cleaner and remove the plug from
the socket.
• Wind up the power cord.
• Empty the container as described in the "Emptying
the containers" paragraph. Clean the vacuum cleaner
as described in the "Maintenance, cleaning and
decontamination" paragraph.
• Store the vacuum cleaner in a dry place, out of reach of
unauthorized personnel.
Figure 8
Maintenance, cleaning and
decontamination
The precautions described below must be taken during
all the maintenance operations, including cleaning and
replacing of the safety filters.
• To allow the user to carry out the maintenance
operations, the vacuum cleaner must be
disassembled, cleaned and overhauled as far as
is reasonably possible, without causing hazards
for the maintenance staff or others. The suitable
precautions include decontamination before
disassembling the vacuum cleaner, adequate
filtered ventilation of the exhaust air from the
room in which it is disassembled, cleaning of
the maintenance area and suitable personal
protection.
Compartments that are not dust-tight must be opened
with suitable tools (screwdrivers, wrenches, etc.) and
thoroughly cleaned.
• Carry out a technical inspection at least once a
year, for example: check the filters to find out
whether the seal of the vacuum cleaner has
been impaired in any way and make sure that
the electric control panel operates correctly.
This inspection must be carried out by the
manufacturer or by a qualified technician.
Use only genuine spare parts supplied and authorized
by the manufacturer.
7
WSS100 - WST100 DV
WARNING!
WARNING!
09/2009