Setting To Work - Connection To The Power Supply; Extensions; Dry Applications - Nilfisk-Advance VHS120N1 Instructions For Use Manual

VHS 120 N1, N6
Setting to work - connection to the power
supply
■ Make sure there is no evident sign of damage to
the vacuum cleaner before starting work.
■ Before plugging the vacuum cleaner into the
electrical mains, make sure the voltage rating
indicated on the data plate corresponds to that of
the electrical mains.
■ Connect the plug into a socket with a correctly
installed ground contact/connection.
■
Make sure that the vacuum cleaner is turned off.
■ The plugs and connectors of the connection
cables must be protected against splashes of
water.
■
Make sure that connections to the electrical
mains and plug are correct.
■ Use the vacuum cleaners only when the cables
that connect to the electricity mains are in perfect
condition (damaged cables could lead to electric
shocks!).
■ Regularly check there are no signs of damage,
excessive wear, cracks or aging on the electric
cable.
When the device is operating, do not:
■ Crush, pull, damage or tread on the cable that
connects to the electrical mains.
■
Only disconnect the cable from the electrical
mains by removing the plug (do not pull the
cable).
■ Only replace the electric power cable with one of
the same type as the original: 12/3 SJT SP20A.
The same rule applies if an extension is used.
■ The cable must be replaced by the manufacturer's
Service Center staff or by equivalent qualified
personnel.
US
C449
WARNING!
WARNING!

Extensions

If an extension cable is used, make sure it is suitable for the
power input and protection degree of the vacuum cleaner.
Maximum length = 20 m
Cable = 12/3 SJT SP20A
WARNING!
Sockets, plugs, connectors and installation of the
extension cable must maintain the IP protection
degree of the vacuum cleaner, as indicated on the data
plate.
WARNING!
Never spray water on the vacuum cleaner: this could
be dangerous for persons and could short circuit the
power supply.
WARNING!
The vacuum cleaner's power socket must be protected
by a differential circuit-breaker with surge current
limitation, that shuts off the power supply when the
current discharged to the ground exceeds 30 mA for
30 msec. or an equivalent protection circuit.

Dry applications

The supplied filters and the bag (if applicable) must be
installed correctly.
WARNING!
Comply with the safety regulations governing the
vacuumed materials.
6
[ NOTE ]
11/2017