Cleaning The Containers; Chip Basket; Liquid Container; Cleaning Or Replacement Of The Safety Filters - Nilfisk-Advance WSS 100 Instructions For Use Manual

WSS100 - WST100 DV

Cleaning the containers

WARNING!
Before proceeding with these operations, turn off the
vacuum cleaner and remove the plug from the power
socket.

Chip Basket

• Clean the container after each emptying (see "Emptying
the chip basket" paragraph).
• Check that the holes are free of dirt; clean them if
necessary.

Liquid container

1 Float ball and support plate
2 Chip basket
3 Container closing band
4 Drain valve
• Empty the liquid container (see "Emptying the containers"
paragraph).
• Open the liquid container closing band (3).
• Lift the motor head.
• Remove the float, its support (1) and the chip basket (2)
• Wash the container with water to remove deposits.
• Open the valve (4) to empty the container.
• Close the drain valve (4).
• Place the float drain, its support and the chip basket back
into position.
• Lock the motor head by using the liquid container closing
band (3).
09/2009
Figure 9
Cleaning or replacement of the safety
filters
1 Safety filters
2 Separator
3 Filter cover
• Open the container closing band (3 fig 9).
• Lift off the motor head
• Remove the filter cover (3) and the separator (2) after
removing the screws.
• Clean the filters (1) with water or replace them if
necessary.
• Install the filter cover (3), the separator (2) and the filters
(1) by replacing the fixing screws.
• Reinstall the motor head and close the container with the
appropriate closing band.

Seal inspection

1 Vacuum hose
2 Sight level hose
• Hoses check
Make sure that the suction connecting hose (1) and the
sight level hose (2) are in a good condition and correctly
fixed.
If the hose is damaged or broken, it must be replaced.
1 Gasket
2 Liquid container
3 Motor head
Replace the seal (1) between the container (2) and the
motor head (3) if it is torn, cut, etc.
8
Figure 10
Figure 11
Figure 12