Table of Contents
Advertisement
PART 1 English
2.3 Rear Panel
1. SAT IN
Connect the digital signal from your LNB on the satellite dish to this connector.
2. SAT OUT
Gives you the possibility to connect an extra receiver (analogue or digital).
3. TV SCART Connector
To connect your receiver to your TV set using a SCART cable.
4. VCR SCART Connector
To connect your receiver to your video recorder using a scart cable. Your video signal will now
be looped through your receiver to your TV set.
5. RS 232 Serial Port
This serial port can be used to connect your PC with your receiver, to download new versions
of software to your receiver.
6. S/PDIF Digital audio output
Use this coaxial output to connect your receiver to the input of your digital audio amplifier.
7. Power ON/OFF Switch
8. Power Cord
Your receiver requires a current of 90~240V AC (Auto-selectable), 50~60Hz +/-5%.
Make sure to check the power specification before connecting your receiver to the wall outlet.
1
Only for model SRT 6010.
FIGURE 3. Rear Panel
1
1
9
Advertisement
Table of Contents
