Power Supply - Panasonic PV-GS400 Operating Instructions Manual

PV-GS400Eng.book 16 ページ ２００４年６月４日 金曜日 午後３時１７分
ª Using the Remote Controller
1
Direct the Remote Controller at the Remote
Control Sensor (36) of the Camcorder and
press an appropriate button.
10˚
15˚
15˚
15˚
≥Distance from the Camcorder: Within
approximately 15 feet (5 meters)
≥Angle: Within approximately 10o in the
upward, and 15o in the downward and
horizontal directions from the central axis
≥The above operating ranges are for indoor use.
Outdoors or under strong light, the Camcorder
may not operate properly even within the above
ranges.
≥Within a 3 feet (1 meter) range, you can also
use the Remote Controller on the LCD Monitor
side of the Camcorder.
Selecting Remote Controller Modes
When 2 Camcorders are used simultaneously,
they can be operated individually by selecting
different Remote Controller Modes.
≥If the Remote Controller Mode of the Camcorder
and that of the Remote Controller do not match,
[REMOTE] Indication is displayed.
Setup on the Camcorder:
Set [REMOTE] on the [INITIAL] Sub-Menu to the
desired Remote Controller Mode. (
Setup on the Remote Controller:
6 1
STILL ADV PAUSE STILL ADV
2
E
;
INDEX STOP
K ∫
SELECT
[VCR1]: Press the [D] Button and [∫] Button
simultaneously. 1
[VCR2]: Press the [E] Button and [∫] Button
simultaneously. 2
≥When the battery in the Remote Controller is
replaced, the mode is automatically reset to
[VCR1] Mode.
16
Before Use
(36)
, , )
-23- -24- -25-
W
5
1
D
INDEX P.B. ZOOM
L

Power Supply

ª Using the AC Adaptor
1
Connect the DC Cable to the Camcorder.
2
Connect the DC Cable to the AC Adaptor.
3
Connect the AC Cable to the AC Adaptor
and the AC Jack.
≥The AC Cable's outlet plug does not fit
entirely into the AC Adaptor jack. A gap will
remain as shown 1.
≥Before connecting or disconnecting the
power supply, set the [OFF/ON] Switch on
the Camcorder to [OFF] and make sure that
[POWER] Lamp is not lit.
ª Using the Battery
Before use, fully charge the Battery.
≥We recommend using a Panasonic Battery.
≥We cannot guarantee the quality of this
Camcorder when batteries from other
companies are used.
1
Attach the Battery to the AC Adaptor and
charge it.
≥Since the Battery will not be charged when
the DC Cable is connected to the AC
Adaptor, disconnect it from the AC Adaptor.
≥The [CHARGE] Lamp lights up, and charging
starts.
≥When the [CHARGE] Lamp goes off,
charging is completed.
≥When the battery is completely discharged,
the [CHARGE] lamp blinks at first, but the
battery is charged normally. When the
temperature of the battery is too high or low,
the [CHARGE] lamp blinks and the charging
time becomes longer than usual.
1