Table of Contents
Advertisement
Wake Up by PCI Card
If you enable this item, it allows activity on an add-in card in one of the PCI slots
to resume the system from a power-saving mode.
Power On by Ring
If this item is enabled, it allows the system to resume from a software
powerdown or a power-saving mode whenever there is an incoming call to an
installed fax/modem. You might have to connect the fax/modem to a mainboard
Wake On Modem connector for this feature to work.
Wake Up On LAN
If this item is enabled, it allows the system to resume from a software
powerdown or a power-saving mode whenever there is an incoming traffic to a
network (LAN) adapter. You might have to connect the LAN card to a mainboard
Wake On LAN connector for this feature to work.
Resume by Alarm
If this item is Enabled, it allows you to set a date and time alarm that will
automatically resume the system from a software power down. When you enable
this feature, new setup items appear to let you set the alarm. Date (of Month)
Alarm lets you select a day from 1 to 31. Time Alarm lets you select a time for
the alarm in hours, minutes, and seconds.
Primary IDE 0
Primary IDE 1
Secondary IDE 0
Secondary IDE 1
When these items are enabled, the system will restart the power-saving timeout
counters when any activity is detected on any of the drives or devices on the
primary or secondary IDE channels.
FDD,COM,LPT Port
When this item is enabled, the system will restart the power-saving timeout
counters when any activity is detected on the floppy diskette drives, the serial
ports, or the parallel port.
PCI PIRQ[A-D]#
When this item is enabled, the system will restart the timeout counters when any
activity is detected on the Interrupt request lines used over the PCI bus.
Default: Disabled
Default: Disabled
Default: Enabled
Default: Disabled
Default: Disabled
Default: Disabled
Default: Disabled
Default: Disabled
Default: Disabled
Default: Disabled
57
Advertisement
Table of Contents
