MATSONIC MS8137C User Manual page 34

J1: Case open
This jumper prevents unauthorized access to your computer
by enabling an alarm that alerts you when your computer case
has been opened.
J4:
Sleep button connector
J5: G-LED2
Editor's Note:
Please supply the information for the items above.
USB2/USB3: USB port 3, 4 and 5, 6
The mainboard has two USB ports installed on the rear edge
I/O port array. Additionally, some computer cases have USB
ports at the front of the case. If you have this kind of case, use
auxiliary USB connectors USB2 and USB3 to connect the
front-mounted ports to the mainboard.
Pin Signal Name
1 VREG_FP_USBPWR0
2 VREG_FP_USBPWR0
3 USB_FP_P0-
4 USB_FP_P1-
5 USB_FP_P0+
WOL1/WOM: Wake On LAN/Wake On Modem
If you have installed a LAN card, use the cable provided with
the card to plug into the mainboard WOL1 connector. This en-
ables the Wake On LAN (WOL) feature. When your system is
in a power-saving mode, any LAN signal automatically re-
sumes the system. You must enable this item using the Power
Management page of the Setup Utility.
Pin Signal Name
1 5VSB
2 Ground
3 SENSE
If you have installed a modem, use the cable provided with
Pin Signal Name
6 USB_FP_P1+
7 Ground
8 Ground
9 Key
10 USB_FP-OC0
28