Installing Add-On Cards - MATSONIC MS8137C User Manual

3. Plug the correct connector on the FDD cable for the
5.25-inch or 3.5-inch drive into the FDD connector (B).
4. Plug a power cable from the case power supply into
the power connector on the FDD.
When you first start up your system, go immediately to the
Setup Utility to configure the floppy diskette drives that you
have installed. See Drive A/Drive B (1.44M, 3.5 in./None) on
page 39 for more information.

Installing Add-on Cards

This mainboard has five 32-bit PCI (Peripheral Components
Interconnect) expansion slots, one 4xAGP slot, and one CNR
slot.
4xAGP Slot
PCI Slots
CNR
Note: Before installing an add-in card, check the docu-
mentation for the card carefully. If the card is not
Plug and Play, you may have to manually configure
the card before installation.
AGP slot
PCI slots
CNR slot
The 4xAGP slot is used to install a graphics
adapter that supports the 4xAGP specifica-
tion and has a 4xAGP edge connector.
PCI slots are used to install expansion cards
that have the 32-bit PCI interface.
The Communications Networking Riser
(CNR) slot can be used to insert a CNR card.
C D 2
C D 1
A G P1
P C I1
P C I2
P C I3
P C I4
B T 1
P C I5
J 1
C N R 1
1 1 1 1
U S B 3
W O M 1 W O L1
25
C A SFA N 1
J P 4
1 1 1 1
1 1 1 1
1 1 1 1
1 1 1 1
J P 1 J 4 1 1 1 1
1 1 1 1
F D D 1
1 1 1 1
U S B 2