Date And Time - MATSONIC MS8137C User Manual

Date and Time

The Date and Time items show the current date and time on
the computer. If you are running a Windows OS, these items
are automatically updated whenever you make changes to the
Windows Date and Time Properties utility.
IDE Devices (None)
Your computer has two IDE channels (Primary and Secondary)
and each channel can be installed with one or two devices
(Master and Slave). Use these items to configure each device
on the IDE channel.
Press <Enter> to display the IDE sub-menu:
CMOS Setup Utility – Copyright © 1984 – 2000 Award Software
IDE HDD Auto-Detection
IDE Primary Master
Access Mode
Capacity
Cylinder
Head
Precomp
Landing Zone
Sector
: Move Enter : Select
F5:Previous Values
IDE HDD Auto-Detection
Press <Enter> while this item is highlighted to prompt the Set-
up Utility to automatically detect and configure an IDE device
on the IDE channel.
Note: If you are setting up a new hard disk drive that sup-
ports LBA mode, more than one line will appear in
the parameter box. Choose the line that lists LBA
for an LBA drive.
IDE Primary/Secondary Master/Slave (Auto)
Leave this item at Auto to enable the system to automatically
detect and configure IDE devices on the channel. If it fails to find
a device, change the value to Manual and then manually config-
ure the drive by entering the characteristics of the drive in the
items described below.
IDE Primary Master
Press Enter
[Auto]
Menu Level
[Auto]
To auto-detect the
0 MB
HDD's size, head . . . on
0
this channel
0
0
0
0
+/-/PU/PD:Value: F10: Save ESC: Exit
F6:Fail-Safe Defaults F7:Optimized Defaults
38
Item Help
F1:General Help