Installing A Sas Or Sata Hot-Swap Hard Disk Drive - MAXDATA PLATINUM 2200 IR User Manual

Installing a SAS or SATA Hot-swap Hard Disk Drive

1. Remove the front bezel if it is installed.
. Press in on the green latch at the front of the hard drive carrier. See letter "A" in the figure
below.
. Pull out on the black lever and slide the carrier from the chassis. See letter "B" in the figure
below.
Figure 17. Removing the Hot-swap Hard Drive Carrier from the Chassis
4. Remove the four screws that attach the plastic retention device or the previously installed hard
drive to the drive carrier. Two screws are at each side of the retention device or the hard drive.
Store the plastic retention device for future use.
Figure 18. Removing the Retention Device from the Hot-swap Drive Carrier
5. Remove the hard drive from its wrapper and place it on an antistatic surface.
6. Set any jumpers and/or switches on the drive according to the drive manufacturer's
instructions.
7. With the drive circuit-side down, position the connector end of the drive so that it is facing the
rear of the drive carrier.
8. Align the holes in the drive to the holes in the drive carrier and attach it to the carrier with the
screws that were attached to the plastic retention device.
MAXDATA Server PLATINUM 00 IR M7
�
5