Installing Or Replacing A Hot-Swap Power Supply; Removing A Hot-Swap Power Supply; Filling Empty Chassis Bays - MAXDATA PLATINUM 2200 IR User Manual

Installing or Replacing a Hot-swap Power Supply

The power supply can be replaced if it, or one of the fans integrated into it, fails. If your server uses
a redundant power supply, you do not need to power down your server to replace the failed power
supply, as long as the remaining power supply is plugged into an AC power source and is functioning.
If you do not have a redundant power supply installed, you must power down your server system
before replacing the power supply.

Removing a Hot-swap Power Supply

To replace the power supply, use the following instructions.
1. (Non-redundant power supply only) Power down the server.
. Remove the AC power cable from the failed power supply.
. Press the green latch at the rear of power supply and pull the power supply from the chassis.

Filling Empty Chassis Bays

A filler panel, drive blank, or empty drive carrier must be installed into any empty power supply /
drive bay.
MAXDATA Server PLATINUM 00 IR M7
Figure 22. Removing a Hot-swap Power Supply
9