Martin ATOMIC 3000 User Manual page 7

• Following the cord cap manufacturer's instructions, connect the yellow and
green wire to ground (earth), the brown wire to live, and the blue wire to
neutral. The table below shows some pin identification schemes.
Wire
brown
blue
yellow/green
I
N S T A L L A T I O N
The Atomic 3000 may be installed in any orientation. The mounting bracket
provides five 12 mm holes for direct fastening or attachment of rigging clamps.
To install the moun ting br acket
1 Place the fixture face down on a table.
2 Place a plastic washer on each mounting bracket stud.
3 Place one end of the bracket on one of the mounting studs. Bend the other
end of the mounting bracket open slightly and work it onto the opposite stud.
4 Place a hand knob on each stud. Tighten both hand knobs to lock the
mounting bracket in place.
B
Atomic 3000 user manual
Pin
live
neutral
ground
Table 1: Cord cap wiring
A
Preparation for use
Marking Screw color
"L" yellow or brass
"N" silver
green
7