Martin ATOMIC 3000 User Manual page 20

A
T O M I C
Chase/Sync toggle
Intensity control
Blinder effect
The optional Detonator remote control provides the following:
• Slider controls for flash rate and intensity
• Momentary push button control of the blinder effect
• Momentary push button for single flash and flash synchronization
• Run/stop toggle switch
• Chase/sync toggle switch
D
A T A C O N N E C T I O N
Important: Do not terminate the data link when using the Detonator!
The Detonator connects to the Atomic 3000 with a 3-pin XLR data cable.
Additional Atomic 3000s may be connected in series, output to input, for remote
control of up to 20 fixtures. Note, however, that the data link must not be
terminated as described DMX controllers.
If a signal splitter is used to branch the data link, it must be placed after the master
fixture (see below), as the splitter does not transmit power to the remote control.
M
O D E S E T T I N G
Important: Connect no more than 1 master to the remote control!
20
D
E T O N A T O R
Run Stop
Chase Sync
Remote controls
Run/stop toggle
Flash rate control
Single flash and
synchronization
Atomic 3000 user manual