BEC 8800N User Manual page 46

PPPoE Service Name: This item is for identification purposes. If it is required, your ISP will
provide you the necessary information. Maximum input is 32 alphanumeric characters.
Authentication Method: Default is AUTO. Please consult your ISP on whether to use PAP, CHAP
or MSCHAP.
Fullcone NAT: Check/uncheck this item to activate/inactivate this function.
Dial on demand (with idle timeout timer) / Inactivity Timeout (minutes) [1-4320]: Check
Enable to activate this function and the following field will be available, so that you can enter the
time value to auto-disconnect the broadband firewall gateway when there is no activity on the line
for a predetermined period of time.
PPP IP extension: Check/uncheck this item to enable/disable this function.
Static IPv4 Address / IPv4 Address: Check Enable to activate this function and the following field
will be available, so that you can enter the IPv4 address (default is 0.0.0.0) to the device.
PPP Debug Mode: Check/uncheck this item to enable/disable this function.
Bridge PPPoE Frames Between WAN and Local Ports: Check/uncheck this item to enable/
disable this function.
IGMP Multicast Proxy: Check/uncheck this item to enable/disable this function.
Click Next to go to next step.
Selected WAN Interface: Select the WAN interface for the IPv4 Default Gateway.
Click Next to go to next step.
DNS Type: Select the appropriate DNS type.
42