Chapter 2 Installing Scan-In-Dex; Installing Software First; Installing Hardware First - Microtek SCAN-IN-DEX 1000 User Manual

Chapter 2 Installing Scan-in-Dex

To simplify the installation of Scan-in-Dex, hardware and software installation have been
combined into a single process. You can choose to install the software first followed
immediately by the hardware, or vice versa; this will not affect the usability of the card
scanner. Both procedures are laid out in this chapter, and determining which procedure
you wish to follow is simply a matter of personal preference.

Installing software first

1. Insert the Microtek Scan-in-Dex CD-
ROM into your CD-ROM drive. The
system will automatically start the
installation process. Follow the on-
screen installation instructions.
2. At the end of the software installation
for Scan-in-Dex, click Finish, then
restart the computer.
3. Plug the Scan-in-Dex USB connector
into the USB port of the computer.
When the "Digital Signature Not
Found" window appears, click Yes to
complete the hardware installation.
After restarting the computer, the
Scan-in-Dex Manager appears on
the Windows task bar. If you do not
see this, check to make sure that
Scan-in-Dex is properly connected to
the computer, and tighten the USB
connection cord in the card scanner.
4 Microtek Scan-in-Dex User Guide

Installing hardware first

1. To install the hardware first, plug the
Scan-in-Dex USB connector into the
computer's USB port. The "Add new
hardware wizard" will appear. Choose
Install from list or specific location,
then click Next.