Lens Mode Ratio [2] - Konica Minolta 7065 Instruction Manual

Lens Mode Ratio [2]

USERSET ratios are used to reduce and enlarge the original image to accommodate
copy paper size, and are available when Lens Mode is selected from the Basic Screen.
These ratios may be changed by the key operator as shown below.
Setting options: User Set
Key Operator Mode Screen
Procedure
1 While pressing [ HELP ], turn power ON. Enter a 4-digit key operator password, then
touch OK to display the Key Operator Mode Screen. (See note.)
2 Touch [2] Lens mode ratio to display Lens Mode Ratio Setting Screen.
3 Touch one of the USERSET ratios you want to change, then enter a ratio from 0.33
~ 4.00, using the keypad.
If a ratio under 0.33 is entered, 0.33 will be displayed.
If a ratio over 4.00 is entered, 4.00 will be displayed.
4 Touch OK to complete the setting.
5 If no further changes are required, proceed to step 7.
6 If other key operator settings are required, touch PREVIOUS SCREEN to restore the
Key Operator Mode Screen.
7 Turn power OFF.
8 Turn the copier power switch back ON to perform copying operations.
NOTE:
If an invalid Key operator password is entered, continue by entering the valid 4-digit password.
Section 12 : Key Operator Mode
Lens Mode Ratio Setting Screen
Initial
Setting Mode
Lens Mode
Ratio
12 12
Key Operator Key Operator
Mode Mode
12 - 15