Section 5 : Copier Management
Power Saver Mode
There are two modes for the Power saver as described below.
Low power mode enables you to conserve energy by maintaining a lower fixing temperature
during periods of copier inactivity.
Shut-off mode conserves even more energy by partially turning OFF the power supply.
CAUTION
During Power Saver mode the copier is still connected to the mains power supply and
power is still applied to certain areas of machine. To avoid any unexpected troubles turn
the power OFF when not using the copier for long periods of time.
Auto Low Power
This function automatically lowers the power after a specified period of copier inactivity.
The Auto low power function can be set to 5 minutes/ 10 minutes/ 15 minutes/ 30 minutes/
60 minutes/ 90 minutes/ 120 minutes/ 240 minutes. Initially, the mode is set to function
after 15 minutes of copier inactivity. For the key operator setting, see p. 12-48 to p. 12-49.
When Auto low power is on, the following message will be displayed on the dimmed Basic
screen.
The [ POWER SAVER ON/OFF ] LED remains dark.
Release Auto Low Power
Press any key on the control panel other than [ START PRINT ] and [ POWER SAVER ON/
OFF ]. The Auto low power will be released and the LCD screen recovers usual brightness.
5 - 2
Basic Screen