Reserve; Set Reserve Job - Konica Minolta 7065 Instruction Manual

Section 6 : Basic Operations

Reserve

The Reserve function allows you to start printing the next job immediately after the present
job is completed. While the first job is printing, you can set up the next job so that the
copier reads in the original image(s) and waits until the first printing is completed.
This section describes the procedure of this function and troubleshooting during the reserve
job setting.
Reserve Specifications
Job settings : 2 (output job and one reserve job)
Job No. : 1 to 15
The reserve job is available to be set after the copier starts to scan for the output job.
If certain conditions occur while a Reserve job is being set, such as activation of Interrupt
mode, mishandled paper, or depletion of paper, the current output job will cease and
the SETTING indicator on the screen will be replaced by INTERRUPT, JAM or ADD
PAPER, as appropriate. Perform the required measure for the situation at hand.
Incompatible Basic Copy Conditions: Interrupt copying, Scanning in Memory copy, Proof
copy
Incompatible Original Scanning Conditions: Resolution (Very High)
Incompatible Applications: Overlay

Set Reserve Job

Procedure
1 The reserve job setting is available when the RESERVE indication on the Basic
Screen appears clear.
Basic Screen: reserve job available
6 - 20
The Job No. assigned to each job will remain until the copier power is
turned off, whether all output jobs are completed or not.
When the Job No. reaches 16, the numbering will return to No. 1 from
the next job assigned to the copier.
Reserve Setting Screen