Dimensions And Clearances; Positioning The Range - AGA Legacy 44 User's Manual & Installation Instructions

Read all instructions before installing or using this appliance.

Dimensions and clearances

Provide adequate clearances between the
range and adjacent combustible surfaces.
These dimensions must be met for safe use of
your range. The location of the electrical outlet
and pipe opening (see Gas Pipe and Electric
Outlet Locations) may be adjusted to meet
specific requirements.

Positioning the Range

The diagrams below show the minimum
recommended distance from the range to
nearby surfaces.
A Min 35 3/8''(89.8cm) Max 36 7/16 (92.5cm)
B Min 43 11/16'' (110cm)
C Min 30'' (76cm)
D Min 3'' (7.5cm) but see below about door
opening.
E Min50'' (127cm)
F Min 18'' (43cm)
G Maximum 13'' (33cm)
The cooktop surround should be level with, or
above, any adjacent work surface. Above
cooktop level a gap of 3" should be left between
each side of the range and any adjacent vertical
surface.
For non-combustible surfaces (such as
unpainted metal or ceramic tiles) this can be
reduced to 1".
Installation Instructions
Save these instructions for future reference.
32
A minimum space of 30" is required between the
top of the cooktop and a horizontal combustible
surface.
The maximum depth for cabinets installed above
cooktops is 13''.
The standard depth of the range is 26
overall.
If the range is to be installed between 24'' deep
cabinets the optional rear spacer should be
fitted to move the range 2'' forward. See the
spacer fitting instruction section of these
instructions.
3 / ''
4