Regulations; For Your Safety; If You Smell Gas; Tools - AGA Legacy 44 User's Manual & Installation Instructions

Read all instructions before installing or using this appliance.

Regulations

Installation of this range must conform with local
codes, or in the absence of local codes, with the
National Fuel Gas Code, ANSI Z223.1/
NFPA.54, latest edition. This range has been
design-certified by CSA International according
to ANSI Z21.1, latest edition.
Read the instructions before installing or using
this appliance. This range becomes hot in use,
the cooktop burners produce exhaust gases.
Take safety precautions - see the safety
warnings in the User Guide, which should be
read together with this installation guide.
Important
• Observe all governing codes and ordinances.
• The range must be properly grounded.
• Save these instructions for the local electrical
inspector's use.

For Your Safety

Do not store or use combustible materials,
gasoline or other flammable vapors and liquids
in the vicinity of this or any other appliance.

If you smell gas

• Open windows.
• Don't touch electrical switches.
• Extinguish any open flame.
• Immediately call your gas supplier
Installation Instructions
Save these instructions for future reference.

Tools

You will need the following tools

Materials

Additional materials you may need:
30
1. Electric drill
2. Masonry drill bit & anchors (only required if
fitting the range on a stone or concrete floor)
3. Steel tape measure
4. Phillips head screwdriver
5. Flat head screwdriver
6. 4mm & 3mm Allen keys
7. Spirit level
8. Pencil
9. Open-end or adjustable wrench
10. Pencil and ruler
11. Pipe wrenches
• Gas line shut-off valve
• Pipe joint sealant or UL-approved pipe thread
tape with Teflon* that resists action of natural
and LP gases. *Teflon: Registered trademark
of DuPont
• Flexible metal appliance connector (1/2'' I.D.).
A 5-foot length is recommended for ease of
installation but other lengths are acceptable.
Never use an old connector when installing a
new range.
• Flare union adapter for connection to gas
supply line (3/4'' or 1/2'' NPT x 1/2'' I.D.)
• Flare union adapter for connection to
pressure regulator on range (1/2'' NPT x 1/2''
I.D.)
• To protect any floor covering under the range
a sheet of 1/4'' thick ply wood or equivalent
large enough to stand the range on