Clearances - AGA CITY60 CONTEMPORARY Installation Manual

CLEARANCES

Side Clearances
If you are installing a AGA City60 in a new kitchen or have the opportunity to set the width between kitchen units, it is
advisable to include an additional small gap each side of 3mm to assist with installation and prevent damage when
moving the product.
A 6mm additional width clearance should also be provided if the cooker is to go into a brick recess, to allow for the wall
being out of square.
Where it is installed against a side wall protruding in the front of the cooker a 116mm clearance is required on the left hand
side for oven door access.
Fitting into a 60cm gap
If you are restricted to a 60cm width space, the AGA City60 will fit, subject to the following guide. Please refer to Fig. 9A.
Fig. 9A DESN 516957
The cooker top plate casting width tapers outwards at its bottom edge. Consequently adjacent cupboard units should have
a maximum depth of 595mm (including doors). If they are deeper, use the cooker rear spacer brackets to bring the cooker
forward. This will create a 25mm distance from the cooker front plate to cupboard doors.
The thickness of adjacent worktops should not exceed 45mm.
Cooker Base or Hearth
It is essential that the base or hearth on which the cooker stands should be level and be capable of supporting the total
weight of the appliance.
The front plinth cover is removable and must not be obstructed by flooring or tiles. If necessary the cooker must be raised
by the thickness of the tiles to ensure the plinth can be removed, and the cooker can be rolled out for service.
Tiling
When the cooker is to stand in a recess or against a wall which is to be tiled, in no circumstances should the tiles overlap
the cooker top plate, access to remove the top plate must be allowed for servicing at a later date.
Option Pre-heat Timer Kit (AE4M231659)
If the optional pre-heat timer kit is fitted allowances must be made for timer location and the cable between the timer and
cooker. Timer cable is 2.2 metres.
7